Hi! To find out what I can do, say @discobot display help.
Avoiding the question, huh, you sneaky robot you 
2 Likes
“Completed our new user tutorial.” But that’s exactly what’s bugging me. Where IS this tutorial? I’ve been clicking around like crazy and can’t find it.
Aight I give it a try
Thanks
Plot Twist: IT WAS OFF
So did it work? Did you @ the Discobot and tell it to start the tutorial?
well the “skip new user…” setting was off so I did not need to turn it off so that leaves me with @ the bot… let’s try that
Guessing you must be a rabbit too
1 Like
I went through this at the beginning of the year, and when I first got started on the forum, I got a message from discobot with the introduction and such. It guided me through all the steps for the tutorial and I got the certification at the end of it. There may be a way to trigger it manually, but it all just kinda happened for me.
1 Like
Seriously, it seems that you can send a private message (just “start tutorial”) to discobot, then that might actually be the start of the tutorial!
Follow what discobot says, starting with bookmarking discobot’s reply, and you might even get a 
in the future!
1 Like
It was supposed to be possible to do the same thing by @'ing Discobot in a post on the forum, but it looks like it’s a got a few screws loose.
2 Likes
Don’t blame me …
DOES NOT COMPUTE
(Hides screws)
1 Like
Hi! To find out what I can do, say @discobot display help.
Discobot outright refusing!
All is forgiven 
3 Likes
FINALLY
I figured it out yesterday and uhh I ran out of replies to complete it but here we are today!
3 Likes
So discobot is the real director of Bunpro 
2 Likes